Kubota 3rd function valve install

 Okay folks, I ordered a tree shear and a grapple for my loader and had to force myself to install 3rd function. The instructions are in the loader install manual. They are as clear as mud.

Every piece of the actual Kubota kit is the quality you expect. The valve itself is 30 plus lbs. 

I guess if anyone can find this post it will be beneficial. 

The main loader valve stays on tractor. The main hydraulic hose must be removed before you can install 3rd function valve from under the tractor. The hose is removed and no longer needed. If you've prepped the valve as per the instructions you add two fittings to tractor where you remove two plugs. Then I sat valve on my chest and rolled under tractor, lifted valve into place and started nuts on studs. The valve mounts behind the loader valve. Once you get this done, the rest is self explanatory. 

I cut a bit too much off joystick rubber boot because the instructions are so confusing.  I may order another boot and correct it, but it will require removing the entire joystick again.

The new joystick is nice with the wires inside and it seems a little larger and closer to armrest.

The nitrogen accumulator mounts outside the loader valve cover box, once you get there you understand.

The main tractor harness was up behind my loader control block and towards the seat. You can still reach it through the loosened cover from the front.

All told, this took me about 6 hours. My dealer has never had anyone order this kit and have no suggestions or recommendations.

He had his guys install a WR Long kit on his tractor that uses the power beyond circuit and he stated it took his service guys 8 hours to install.

I knew I didn't want anyone else working on my tractor!

I'll include some images but I don't think I will get under tractor to get images unless someone asks.

Note the number of hydraulic coupler covers and laugh.

I do highly recommend the factory Kubota kit!